Printed Yagi Antenna - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.
-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews
 -- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

sag
 Post subject: Printed Yagi Antenna
Posted: Sat Feb 04, 2006 10:34 am 
Hay all,
I want to design a printed Yagi-Uda antenna, does anyone know how to do it? do I print at both sides of the material, where do I connect the parazitic elements etc.
Freq is not important as long as you give you answers in wave-lenght terms.
10x




Posted  11/12/2012