Visit Thanks for visiting Thanks for visiting the RF Cafe Archives Thank you for visiting RF Cafe Thank you for visiting the RF Cafe Archives!

chip antenna question - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews
-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

 Post subject: chip antenna question
Posted: Tue Oct 04, 2005 5:08 am 

Joined: Tue Oct 04, 2005 5:04 am
Posts: 1
I am currently designing a zigbee sensor module for my graduate project. I am planning to design without a RF SPDT switch due to cost limitations. That is, one antenna for Tx and one antenna for Rx. Since chip antennas are dependent on the layout of the board, are there any disadvantages in designing two chip antennas in one board.
Hope someone can help me out.

Posted  11/12/2012