convert CAD iges to NEC file - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews
-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

srikanthgh
 Post subject: convert CAD iges to NEC file
Posted: Mon Jun 06, 2005 10:38 am 
Hello,

Can anybody tell me if there is a free software that converts .IGES or .STEP files to .NEC format.
NEC is an antenna simulation software.

thanks!
Srikanth



Posted  11/12/2012