ADS simulation, output power VS input power? - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

emirh
Post subject: ADS simulation, output power VS input power?
Unread postPosted: Mon May 09, 2005 12:06 pm
Offline
Lieutenant

Joined: Tue Feb 08, 2005 6:26 pm
Posts: 2
How can I simulate output power VS input power of PA in ADS?

It looks lik i don not have licencee for HB and LSSP simulation, is there any other way? can anyboady help me here?

Top
Profile

Guest
Post subject:
Unread postPosted: Mon May 09, 2005 1:13 pm

You need HB.

Top

emirh
Post subject:
Unread postPosted: Tue May 10, 2005 7:38 am
Offline
Lieutenant

Joined: Tue Feb 08, 2005 6:26 pm
Posts: 2
It turns out that i have license for harmonic balanc simulation! It is the first time im using ADS, can anyboady tell me how to make simulation: input power VS ouputpower?

Top
Profile

Guest
Post subject:
Unread postPosted: Tue May 10, 2005 9:36 am

When I begun using ADS i was very please with the presence of the function Insert->Canevas.

This can allow you to insert a test setup for device, including power sweep.

Of course you need to have a non-linear device model, of a pout-pin data table model.

Posted 11/12/2012