AGC Amplifier circuit - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

Guest
Post subject: [AGC Amplifier circuit]
Unread postPosted: Mon Mar 07, 2005 8:20 pm

Is there anybody know how I can design an AGC circuit with a pin attenuator at 5GHz for wireless lan ?

Regards,
Jimmy :-D

Top

Guest
Post subject: AGC @ 5 GHz
Unread postPosted: Sun Mar 13, 2005 10:22 pm

Hi!
A bit more information is necessary. Is this AGC in the Tx or the Rx path?

If Rx, is there an IF signal point available?

Or is it just the voltage variable attenuator you're asking about?

Good Luck!

Top

Guest
Post subject: RF AMP
Unread postPosted: Sun Apr 10, 2005 1:41 am

I am sorry for late response.
I was away for a while. There is no IF signal now. I could use attenuator if possible.

Jimmy
:roll:

Top

Guest
Post subject: Re: RF AMP
Unread postPosted: Sun Apr 10, 2005 6:26 pm

Guest wrote:
I am sorry for late response.
I was away for a while. There is no IF signal now. I could use attenuator if possible.

Jimmy
:roll:

Who exactly are you rolling your eyes at?

Posted 11/12/2012