|
|
Need specialist / expert advice on Antenna & Circuit Co- - RF
Cafe Forums
|
Guest Post subject: Need specialist / expert advice on Antenna &
Circuit Co- Posted: Fri Oct 07, 2005 4:05 am Sub: Need specialist
/ expert advice on Antenna & Circuit Co-Simulation using Agilent
ADS
Is it possible to co-simulate in Agilent ADS Between
HB (Nonlinear Circuit schematic) with Momentum (Antenna design).
Basically I want to vary the Power Levels dynamically for my antenna
input & monitor the radiation patterns simultaneously.
If not, is there any other tool does this job!!!
Thanx,
Top
Guest Post subject: Antenna and Circuit Co-simulationPosted:
Wed Oct 12, 2005 5:28 pm Hi!
Your question implies a belief
that the antenna's radiation patttern varies with power. This is not
normally the case, which is why such simulations are usually done separately
- both because they can be, and because there's a lot less work involved
with splitting a system up and analyzing each piece.
Good Luck!
Top
Guest Post subject: Posted: Fri Oct 14, 2005
1:51 am It's the Fields not he radiation pattern...
I mean
I should be able to see E & H fields when I cosimulate with circuit
engine...
Is it possible???
Posted 11/12/2012
|
|
|