USB and RS 485 Programming - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

Design_Engineer
Post subject: USB and RS 485 Programming
Unread postPosted: Tue Mar 09, 2004 12:12 pm
Offline
Lieutenant
User avatar

Joined: Tue Mar 09, 2004 12:08 pm
Posts: 1
Location: Chicago, IL
Hello All:
I am a design Engineer at a small start up firm. I know and have programmed serial Rs-232 devices. Now, I have to program a small pump which is 485 based. Further, I would like to use multi-drop as the
next project I know involves using, X-Y-Z stages along with the pump to create a robotic machine. Any samples or tips on using RS485 pgms will be helpful.
Taposh

Top
Profile

JGP
Post subject: USB and RS 485 Programming
Unread postPosted: Tue Mar 09, 2004 8:49 pm

Welcome to forum!

I read your information with interest. Below please, click on this link. I thought it might help you.

http://www.ontrak.net/Programming.htm

Sincerely,

John Pereira

Posted 11/12/2012