how to design a rail-to-rail amplifier in low supply voltage - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

leebluer
Post subject: how to design a rail-to-rail amplifier in low supply voltage
Unread postPosted: Tue Jul 13, 2004 11:30 pm
Offline
Lieutenant

Joined: Tue May 11, 2004 9:43 pm
Posts: 1
how to realize a rail-to-rail amplifier in low supply voltage, for example 1.5v. can anyone give me some advice? i refer to some papers, but i think they are too complicated. i need some help on it.

thanks :(

Posted 11/12/2012