mixer simulation - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

Karthik
Post subject: mixer simulation Posted: Mon Dec 05, 2005 4:47 pm
Hi,

I have been trying to simulate (as part of a down converter system) a mixer at Ku band using Ansoft Designer. I wanted to simulate the effect of the mixer phase response on the output phase of my system. Does anyone know how to model/incorporate phase information in the mixer block in Designer? I can play around with the conversion gain and the power levels in the IM products using the spur table, but how do I include phase information?

Posted 11/12/2012