pls help....thanx - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

beginner
Post subject: pls help....thanx
Unread postPosted: Thu Jun 09, 2005 4:21 pm

Dear all,

I am a beginner in filter design, pls help.
I am designing a butterworth bandpass filter using capacitively coupled resonator.

i using 2 resonators,
1 coupling capacitor C12,
1 input coupling capacitor C1,
1 output coupling capacitor C2,
C1=C2

Is it the the capacitors in the two resonators same value? which is
Co- C12- C1 = Co- C12- C2 ??

If not, pls give some advices. Thanx a lot.

Top

beginner
Post subject:
Unread postPosted: Fri Jun 10, 2005 12:06 am

Anyone pls help me...i am near the end of the road now...pls...

Top

Guest
Post subject: Band-pass filter
Unread postPosted: Fri Jun 10, 2005 12:53 am

In general, the shape of the curve varies with the value of C12. Its value depends on the loaded Q of the two resonators.

More later.

Good Luck

Posted 11/12/2012