NTU information - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

guest
Post subject: NTU Posted: Fri May 13, 2005 3:17 pm
Hello,

I am planning to enter NTU for a master's degree (www.ntu.edu).
(National Technological University)

Any comments, or opinions on the value of this degree are welcome and encouraged.

Thank you !

Experience is welcome !

Top

Kirt Blattenberger
Post subject: Posted: Fri May 13, 2005 3:42 pm

Site Admin

Joined: Sun Aug 03, 2003 2:02 pm
Posts: 308
Location: Erie, PA
Greetings:

I took a couple Master's courses (microwave engineering, statistics) through NTU way back in 1990. All my classes came on VCR tapes. Although the filming was good, I found I did not like the lack of interaction and being in the classroom. Most of the period is spent watching an instructor's hand writing something while listening to a disembodied voice. Maybe things have changed significantly in 15 years, though.

- Kirt Blattenberger

Top

guest
Post subject: NTUPosted: Fri May 13, 2005 4:08 pm
I am working and will be taking this while working and also have a collegue taking the same courses with me. I am not using this to gain employment, but to finish an MS degree.

Posted 11/12/2012