RF Design Engineer Needed - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

Kirt Blattenberger
Post subject: RF Design Engineer Needed Posted: Wed Jul 18, 2007 10:17 am

Site Admin

Joined: Sun Aug 03, 2003 2:02 pm
Posts: 308
Location: Erie, PA
Greetings:

General Electronic Devices (GED) is in need of an RF design engineer to handle frequency synthesizer projects. GED is high volume manufacturer of standard and custom electronic devices such as VCOs, OCXOs, VCXOs, TCXOs, VCTCXOs, DROs, Frequency Translators, Synthesizers, Microwave Amplifiers, Clock Oscillators and Crystals. They are located in Southern California.

Please take a moment to review their listing here on the RF Cafe Job Board. If you are not currently looking for a new job but know someone who is, please do him/her a favor and pass this along. Thanks.

_________________
- Kirt Blattenberger
RF Cafe Progenitor & Webmaster

Posted 11/12/2012