1-port calibration - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

Yariv3G

Post subject: 1-port calibration

Posted: Mon Apr 03, 2006 4:13 am

Captain

Joined: Mon Apr 03, 2006 4:06 am
Posts: 8

Hi,
I am doing twice-1-port calibration for a 2-port device mounted on a fixture, due to the fact that I have noe real "Thrugh" even not on the commercial calibration structure. Is there a way to post process this data and get a proper 2-port calibration data that I can then embed into the Agilent ENA?
Thanks for any hints.
Yariv3G

_________________
R&S RF Application Engineer

Posted 11/12/2012