Projection for HEIGHT and CLUTTER Data files - RF Cafe Forums

The original RF Cafe Forums were shut down in late 2012 due to maintenance issues - primarily having to spend time purging garbage posts from the board. At some point I might start the RF Cafe Forums again if the phpBB software gets better at filtering spam.

Below are the old forum threads, including responses to the original posts.

-- Amateur Radio
-- Anecdotes, Gripes & Humor
-- Antennas
-- CAE, CAD, & Software
-- Circuits & Components
-- Employment & Interviews

-- Miscellany
-- Swap Shop
-- Systems
-- Test & Measurement
-- Webmaster

marsbar

Post subject: Projection for HEIGHT and CLUTTER Data files

Posted: Mon Feb 15, 2010 6:59 pm

Lieutenant

Joined: Mon Feb 15, 2010 6:46 pm
Posts: 1

Hi,

I have Height and Clutter data files that have a projection that is not correct. So when I load those files along with my site files they do not match up. My sites are using NAD 27 projection (which is correct). How do I change the projections of the heights and clutters? By the way I am using Asset SW.

Thanks

Paul Chriss

Post subject: Re: Projection for HEIGHT and CLUTTER Data files

Posted: Fri Feb 26, 2010 12:49 pm

Captain

Joined: Sat Mar 04, 2006 10:12 am
Posts: 12

Would this NADCON software be of any use to you. Is it just that your data needs to be converted to a new epoch (NAD83 vs. NAD27)?

http://www.ngs.noaa.gov/TOOLS/Nadcon/Nadcon.shtml

Posted 11/12/2012